The PVFT1 terminator cap should be installed on all unused networking ports (splitters, multi-switches, etc.) to prevent unwanted signals from causing interference. The PVFT1 will also help to protect the port from water and corrosion damages. The PVFT1 should NOT be used on powered ports if voltage is present. 100 terminators per bag.
Terminator caps should be used on all unused TV networking ports to prevent signal ingress and therefore interference. “Terminators” should also be used on switch ports, splitter ports and any other unused networking and signal dividing ports to reduce reflection and help prevent water migration.This terminator should NOT be used on any powered ports. If voltage is present on the port, do NOT use this type terminator as the internal resistor can overheat.For powered (voltage present) ports use our part number PVPC.
- 75 OHM
- All open or unused ports of splitters, multi-switches, etc. should be terminated.
- Terminators diminish signal loss and help prevent signal ingress and egress.
- Provides for good impedance matching to reduce reflection.
- Helps prevent water migration into open ports.
- Bag of 100