 Support DVB protocol
DVB Data Service Reception
Support MPE (multiprotocol encapsulation)
Digital Satellite TV and Radio Program Receiving
Real time Digital Video Recording (DVR) and
 Scheduling Recording
Time-shifting
Electronic Program Guide (EPG)
Still Frame Capture
FTA Multi-Channel Preview
Transponder, Satellite Auto Scan
Viewing and Schedule Recording Different DTV
Channels Simultaneously
MPEG-II
Software Upgradeable
Video Quality Adjustment
Favorite List
TeletextSystem requirements: Windows 98SE/ME/2000/XP
500MHz CPU or above
128M RAM or above
VGA Card with at least 8MB Memory
Sound Card
Microsoft Direct X 8.1 or above
Digital Satellite Dish & LNB Tuner: Input terminal: F-type 75 Ohm
Receiving frequency: 950~2150 MHz tuning range
Input level: -65~-25dBm
Support MCPC and SCPC Symbol rate: 2~45Msps
QPSK filter: Root-raised cosine filter with roll-off 0.35
FEC: 1/2,2/3,3/4,5/6,7/8 and Auto LNB supply voltage: 13V/18V
DiSEqC: 1.2
Support Data Burst & Tone Burst
Antenna and LNB control: 22KHz Tone
Max. LNB supply current: 400mA with short circuit and surge protection PCI bus: PCI 2.2 compliant
Host bus burst rate: 132 MB/S
Host bus width: 32 bit Demultiplexing Max No. Section filtering: 32PIDs
Engine: software
Stream capture: PES & TS |
Also use it for Internet via Satellite (service subscription required) VisionDTV VisionData is a program to let you receive data or connect to internet via satellite. But you still need 3rd party application program to process the data. VisionData just let you to filter the stream and get specific data. Go to download support to read the manual and download the drivers. NOTE: The 2 F-Connectors you see on the board are as follows: One is used for the satellite signal input. The other is used as loop-through to connect the signal to another satellite receiver. It is not intended to connect it to a TV.
To be able to view the picture on your TV, your PC must have a video output. Otherwise, you are limited to viewing the channels on your computer screen.
|
