Only $59.99

• This interface allows all receivers without DiSEqC 1.2 protocol to control an HH Motor. Controls and displays rotor position.  

• Easy to use, it allows in 5 minutes to perfectly point a dish with the help of a field signal strength meter.

• This unit works with the STAB HH100 or HH120 or any other DiSEqC Motor and can control the unit and store up to 50 Positions

• The MS220 generate the following commands: GO EAST, GO WEST, GO TO "0" (South), and limit set. It is connected between the motor and the receiver.

• The MS220 is a perfect tool for receivers that don't have DiSEqC 1.2 or USALS capabilities.  It allows the receiver owner to add a DiSEqC 1.2 motor to move the satellite dish.

• IR Remote control included.

The MS220 interface is a DiSEqC 1.2 codes generator which has been specially designed to be connected to all analogue and digital receivers with no direct motor control system. Connected by coaxial cable between motor and receiver, it enables the motor to be driven in all functions using the provided remote control: Move East and West, memorize satellite positions, automatic re-calculation, limits configuration, re-alignment, direct recall of 49 memorized positions. Easy to use, the interface is fed by 110 VAC voltage and is provided with a display indicating position and some other functions.

 

NOTE:  These are European version units with 220V power supply. 

To operate in the USA, you will need to buy a 220V to 110V converter (you can find these at a Radio Shack store)

Channels List

English

عربي

Español