Wiring The Actuator (wires not included with actuator):
The actuator line is comprised of five stranded copper wires.
Two 12 or 14 gauge stranded wires are used to power
the motor and
Two color-coded 18 or 22 gauge shielded wires connect
to the sensor.
These actuator wires should be connected to the appropriate terminals on
the back of the receiver (or a separate actuator power supply).
Like the servo motor wires, the Two shielded motor sensor wires provide
pulse, and ground. The vast majority of actuator motors do not require
power to be hooked to the sensor. Look inside the actuator housing. If
there are only two wires connected to the sensor, then hook up pulse and
ground to their respective terminals. IF there are three wires connected
to the sensor, and pulse and ground interchangeably to the other two
sensor wires, then use 3 wires.
The two large stranded wires connect to the large wire terminals at the
actuator motor and to the motor wire "M1" and "M2" terminals on the back
of the receiver or
actuator controller. Now try to move the dish to the east or west;
if the dish moves in the direction opposite to the on intended, reverse
the wires connected to the motor wire "M1" and "M2" terminals.