|
|
30-AP16
16dB FIXED 1GHz MINI F-TYPE ATTENUATOR PADSRF ATTENUATOR
|
 |
 |
In-Line RF Attenuators Attenuators reduce the full range of RF signals by a set amount. In "tuning" video distribution systems, it is often easier to over amplify the signals, then reduce them where desired. -
Screw these
attenuator pads in-line with coax cable and reduce signal
strength by rated amount. Try different combinations until you
get the best picture quality. Use to balance signal strength
from different sources.
-
This in-line attenuators can be inserted in coaxial cable feeds to reduce signal amplitude levels. Combinations of attenuators may be used together to create greater insertion losses. For example, if a cable feed was found to have a signal level of 25 dBmV, and a level of only 5 dBmV is desired, then one 20dB could be used create a 20 dB insertion loss, thereby reducing the signal level from 25 dBmV down to 5 dBmV. An attenuator is a passive microwave component which, when inserted in the signal path of a system, reduces the signal by a specified amount. They normally possess a low VSWR which makes them ideal for reducing load VSWR in order to reduce measurement uncertainties. They are sometimes used simply to absorb power, either to reduce it to a measurable level, or in the case of receivers to establish an exact level to prevent overload of following stages.
FEATURES
- Nickel-plated, solid brass body
- Monolithic ceramic printed circuit board,
- ensuring rugged construction
- Etched glaze-type resistors provide±5%
- accuracy and excellent return loss
- 22-gauge spring steel center pin
Specifications
- Bandwidth:5MHz to 1 GHz (For CATV signal)
- Return loss:20dB typical
- Accuracy:±5%
Related Products:
|
Continue SHOPPING
|
