Features:
- DirecTV Phase 3 compatible
- High port-to-port isolation and Unity gain on satellite ports
- Low 1.5dB insertion loss on antenna port
- All rear panel connection access allows rack or wall mount flexibility
- PIN diode matrix reduces polarity transfer time and digital artifacts providing consistent picture quality
- Polarity is selected by receiver supplied voltage (14V/18VDC) compatible with most DTH satellite services
Ideal solution for DIRECTV and FTA Satellite TV receivers
All Multi-Switches described on this page accept inputs from 13/17V and 14/18V switching systems, and are compatible with all the mini-dish systems on the market today.
How does it work?
When your satellite dish receiver is on, it normally sends one of two DC voltages up the coax to the dish antenna. This DC voltage normally tells the LNB (the receiver electronics in the dish) which of two bands of signal bands to receive. With a Multi-switch installed and connected to a dual LNB (one for each of the two signal bands), the Multi-switch see the "request" from a satellite dish receiver, it then switches through one of the signals. Your receiver does not react any differently when connected to a Multi-switch and the picture quality or signal strength is not degraded
Local Channels, no problem!
The Multi-switch includes an input for regular VHF/UHF TV signals. This can be an antenna on the roof or a signal from a cable TV provider. Use a
Diplexer at the satellite dish receiver to split the two signals (antenna/cable or dish). The Diplexer will allow a single coax cable to carry all the signals for the Multi-switch. One Diplexer will be required at each satellite dish receiver where you want the ability to watch antenna or cable TV channels. All four outputs do not have to be used.
