5 X 8 Multi-Switch
DirecTV Approved!!!
For use with DirecTV Plus & Para Todos
Perfect Vision Multi-switch designed to connect 5 inputs to 8 independent outputs. Allows reception of satellites from two or three satellites using multiple LNBs in a residential application. Enables the reception of DIRECTV DIRECTV PARA TODOS™ Channels™ and HDTV feeds. Includes DC power supply.
KEY FEATURES:
Easy Installation:
• Easily connect up to eight satellite receivers to your satellite dish
• Connect an additional off air antenna or cable input.
• EASY INSTALL: Save time by not having to remove integrated multi-switches embedded in your satellite dish.
• Can be used indoors and outdoors
Quality and Performance:
• Weather resistant design
• Contains an ultra low-noise built in amplifier
Applications:
• For use with up to eight satellite receivers
• Works with most dbs systems
SPECIFICATIONS:
Input frequency range: 950- 2150 MHz, 54- 806 MHz (UHF/VHF)
Output Frequency Range: 54- 2150 MHz (Each Output)
Insertion Loss: -5db 54- 806 MHz, 0db 950- 1750 MHz, -2dB 1751-2150 MHz
Cross Polar Isolation: 30dB min
Current Consumption: 60mA
Power Adaptor: 120 VAC 60Hz Input, 24 VOC 1A Output
22KHz Tone Output: 22 + 4 KHz continuous, 650 + 300 mVp-p
Ideal solution for DIRECTV, TiVo and FTA Satellite TV receivers
All Multi-Switches described on this page accept inputs from 13/17V and 14/18V switching systems, and are compatible with all the mini-dish systems on the market today.
How does it work?
When your satellite dish receiver is on, it normally sends one of two DC voltages up the coax to the dish antenna. This DC voltage normally tells the LNB (the receiver electronics in the dish) which of two bands of signal bands to receive. With a Multi-switch installed and connected to a dual LNB (one for each of the two signal bands), the Multi-switch see the "request" from a satellite dish receiver, it then switches through one of the signals. Your receiver does not react any differently when connected to a Multi-switch and the picture quality or signal strength is not degraded
Local Channels, no problem!
The Multi-switch includes an input for regular VHF/UHF TV signals. This can be an antenna on the roof or a signal from a cable TV provider. Use a
Diplexer at the satellite dish receiver to split the two signals (antenna/cable or dish). The Diplexer will allow a single coax cable to carry all the signals for the Multi-switch. One Diplexer will be required at each satellite dish receiver where you want the ability to watch antenna or cable TV channels. All four outputs do not have to be used.
