|
|
Home :
Installation Supplies : Cable
Fishing Tool
Bergstrom POLE
kit
A tool for fishing cable through walls
and ceilings.
Only
$126.00
Pole Kit includes:
-
5x Standard Ceiling Red poles at 5 ft.
each
-
1x Thin Wall White pole at 5 ft.
each.
-
2x Thin Wall Orange poles at 5 ft.
each.
-
1x Carrying container.
-
2x No-Tape-Tool
(attached to pole)
-
1x Grabber-Tool
(attached to pole)
|
|
|
|
|
Patent No. 5,915,770 |
 |
|
|
|
The Pole's
patented design is the most versatile tool available for fishing cable through
ceilings and walls. The Pole will speed your cabling work and will be the
only tool you need for fishing cable.
The Pole's
strength, stiffness and flexible design makes it easy for you to fish cable
through virtually any enclosed area, even in the most difficult situation.
- TIP 1. Aluminum, bullet shaped tip with
large hole to attach wire directly or to attach wire capturing device
- CONNECTOR 1: Brass connector with female
threads.
- CONNECTOR 2: Brass connector with male
threads.
- BODY: Red fiberglass body. It's hollow
construction makes it both rigid and flexible.
- No Tape Tool: The harder you pull, the
tighter the "No Tape Tool" holds the cable! For Illustrated Instructions.
PULLS WIRE
- across drop ceilings, sheet rock, trusses,
bar joists, etc.
- through enclosed ceilings with ease
- under floors
- through tight crawl spaces
ALSO:
- provides safety with non-conductive material
- captures wire with the GRABBER TOOL
- pushes wire into dead end places
PULLS WIRE AND
- pierces insulation in walls
- moves up or down walls
- provides safety with non-conductive material
- AND MORE!
Use a 12 gauge wire to form a capture tool by
bending it as shown above. Tape the wire to the pole using electrical tape.
The No Tape Tool allows you to
attach the cable without using tape. The harder you pull, the tighter it holds
the cable.Tips for using The Pole:
- Push the pole and pull the cable behind for
the best performance of the pole.
- A small drop of oil on the threads every few
months keeps them running smoothly.
- If the fiberglass of the pole is badly
scratched during use it may give you a sliver. Use a rag to rub vigorously
over the area to return the smooth finish.
- Always use the rounded tips front and rear
of the assembled poles so threads are not exposed and damaged.
|
Continue SHOPPING
|
